Selecting Cutting Data Tests for Cutting Data Modeling Using the Colding Tool Life Model

Daniel Johansson, Ville Akujärvi, Sören Hägglund, Volodymyr Bushlya, Jan Eric Ståhl

Research output: Chapter in Book/Report/Conference proceedingPaper in conference proceedingResearchpeer-review

112 Downloads (Pure)

Abstract

An analysis on selecting cutting speed, cutting feed and depth of cut when collecting data for the Colding Tool Life Model based on Woxen's Equivalent Chip Thickness was performed to achieve the lowest possible model error. All possible combinations of a large data set were evaluated with regard to model error. This work shows that an increase of ratio between the highest and lowest cutting speed, feed, depth of cut and tool life within the five included tool life tests increases the likelihood of an accurate model. Further, to ensure an accurate model, it is not enough to have a large ratio of one single parameter, but a large ratio in all parameters is needed. The paper also presents a suggestion on how to select the cutting data points, derived from the best performing tool life models. It is concluded that one should aim to have one pair of cutting data points with equal equivalent chip thickness while varying cutting speed and three more test points with different equivalent chip thickness.

Original languageEnglish
Title of host publicationProcedia CIRP
Pages197-201
Number of pages5
Volume72
DOIs
Publication statusPublished - 2018 Jan 1
Event51st CIRP Conference on Manufacturing Systems, CIRP CMS 2018 - Stockholm, Sweden
Duration: 2018 May 162018 May 18

Publication series

NameProcedia CIRP
PublisherElsevier
ISSN (Print)2212-8271

Conference

Conference51st CIRP Conference on Manufacturing Systems, CIRP CMS 2018
Country/TerritorySweden
CityStockholm
Period2018/05/162018/05/18

Subject classification (UKÄ)

  • Production Engineering, Human Work Science and Ergonomics

Keywords

  • Colding Equation
  • Cutting data
  • Taylor
  • Tool Life
  • Turning

Fingerprint

Dive into the research topics of 'Selecting Cutting Data Tests for Cutting Data Modeling Using the Colding Tool Life Model'. Together they form a unique fingerprint.

Cite this