Reformed Methanol Gas as Homogeneous Charge Compression Ignition Engine Fuel

Research output: Chapter in Book/Report/Conference proceedingPaper in conference proceeding

Abstract

Hydrogen has been proposed as a possible fuel for automotive applications. Methanol is one of the most efficient ways to store and handle hydrogen. By catalytic reformation it is possible to convert methanol into hydrogen and carbon monoxide. This paper reports an experimental investigation of Reformed Methanol Gas as Homogeneous Charge Compression Ignition (HCCI) engine fuel. The aim of the experimental study is to investigate the possibility to run an HCCI engine on a mixture of hydrogen and carbon monoxide, to study the combustion phasing, the efficiency and the formation of emissions.

Reformed Methanol Gas (RMG) was found to be a possible fuel for an HCCI engine. The heat release rate was lower than with pure hydrogen but still high compared to other fuels. The interval of possible start of combustion crank angles was found to be narrow but wider than for hydrogen. The high rate of heat release limited the operating range to lean (glmg3) cases as with hydrogen. On the other hand, operation on extremely lean mixtures (glme6) was possible. The operating range was investigated using intake air temperature for control and also this control interval was found to be narrow but more extensive than for pure hydrogen, especially when richer cases were run. The maximal load in HCCI mode was a net Indicated Mean Effective Pressure (IMEPn) of 3.5 bar for RMG. This is the same maximum IMEPn as for hydrogen. It is about half the load possible in Spark Ignition (SI) mode and about half the maximal load in HCCI mode with other fuels. For the loads where HCCI operation was possible, indicated thermal efficiency for HCCI was superior to that of SI operation. The indicated overall efficiency of the engine-reformer system is as high for SI as for HCCI operation when RMG is used as fuel. NOx emissions were, as expected, found to decrease when the equivalence ratio was lowered. High levels of carbon monoxide were found in the exhaust. Emissions of hydrocarbons were detected, probably originating from evaporated and partially oxidized lubrication oil.

Details

Authors
  • Ola Stenlåås
  • Magnus Christensen
  • Rolf Egnell
  • Per Tunestål
  • Fabian Mauss
  • Bengt Johansson
Organisations
Research areas and keywords

Subject classification (UKÄ) – MANDATORY

  • Atom and Molecular Physics and Optics
  • Other Mechanical Engineering

Keywords

  • HCCI, Reformed Methanol, Engine, Combustion
Original languageEnglish
Title of host publicationSAE Special Publications
PublisherSociety of Automotive Engineers
Pages127-140
Volume2004
Publication statusPublished - 2004
Publication categoryResearch
Peer-reviewedYes

Publication series

Name
Number1896
Volume2004

Total downloads

No data available