Simultaneous Visualization of Hydrogen Peroxide and Water Concentrations Using Photofragmentation Laser-Induced Fluorescence
Research output: Contribution to journal › Article
A concept based on photofragmentation laser-induced fluorescence (PFLIF) is for the first time demonstrated for simultaneous detection of hydrogen peroxide (H2O2) and water (H2O) vapor in various mixtures containing the two constituents in a bath of argon gas. A photolysis laser pulse at 248 nm dissociates H2O2 into OH fragments, whereupon a probe pulse, delayed 100 ns and tuned to an absorption line in the A2Σ+ (v = 1) ← X2Π(v = 0) band of OH near 282 nm, induces fluorescence. The total OH fluorescence reflects the H2O2 concentration, while its spectral shape is utilized to determine the H2O concentration via a model predicting the ratio between the fluorescence intensities of the A2Σ+ (v = 1) → X2Π(v = 1) and the A2Σ+ (v = 0) → X2Π(v = 0) bands. The H2O detection scheme requires that the bath gas has a collisional cross-section with OH(A) that is significantly lower than that of H2O, which is the case for argon. Spectrally dispersed OH fluorescence spectra were recorded for five different H2O2/H2O/Ar mixtures; the H2O2 concentration in the range of 30–500 ppm and the H2O concentration in the range of 0–3%. Fluorescence intensity ratios predicted by the model for these mixtures agree very well with corresponding experimental data, which thus validates the model. The concept was also demonstrated for two-dimensional imaging, using two intensified charge-coupled device (CCD) cameras for signal detection. Water content was here sensed through the different temporal characteristics of the two fluorescence bands by triggering the two cameras so that one captures the total OH fluorescence while the other one captures only the early part, which mainly stems from A2Σ+ (v = 1) → X2Π(v = 1) fluorescence. Hence, the H2O2 concentration is reflected by the image of the camera recording the total OH fluorescence, whereas H2O concentration is extracted from the ratio between the two camera images. Quantification of the concentrations was carried out based on calibration measurements performed in known mixtures of H2O2 (30–500 ppm) and H2O (0–3%) in bulk argon. The detection limits for single-shot imaging are estimated to be 20 ppm for H2O2 and 0.05% for H2O. The authors believe that the concept provides a valuable asset in, for example, pharmaceutical or aseptic food packaging applications, where H2O2/H2O vapor is routinely used for sterilization.
|Research areas and keywords||
Subject classification (UKÄ) – MANDATORY
|Number of pages||10|
|Publication status||Published - 2017 Sep 1|