Development of a simulation model to study tool loads in pcBN when machining AISI 316L

Forskningsoutput: TidskriftsbidragArtikel i vetenskaplig tidskrift

Abstract

This paper presents the development of a FE-simulation model to predict the mechanical stresses and thermal loads that a cutting tool of polycrystalline cubic boron nitride (pcBN) is subjected to, when machining AISI 316L. The serrated chip formation of AISI 316L has a major impact on the periodic loads acting on the cutting tool. Therefore, it is vital to correctly model this serrated chip formation. One of the major difficulties with FE-simulations of metal cutting is that the extreme deformations in the workpiece material, often leads to a highly distorted mesh. This paper uses the Coupled Eulerian-Lagrangian (CEL) formulation in Abaqus/Explicit, where the workpiece is modelled with the Eulerian formulation and the cutting tool by the Lagrangian one. This CEL formulation enables to completely avoid mesh distortion. To capture the chip serration process, the workpiece material is described with the Johnson-Cook damage model. The FE-simulation results are validated via comparison of the modelled cutting forces, chip serration frequency, and contact length against experimental ones.

Detaljer

Författare
Enheter & grupper
Forskningsområden

Ämnesklassifikation (UKÄ) – OBLIGATORISK

  • Tribologi

Nyckelord

Originalspråkengelska
Sidor (från-till)2853-2865
Antal sidor13
TidskriftInternational Journal of Advanced Manufacturing Technology
Volym96
Utgåva nummer5-8
Tidigt onlinedatum2018 feb 26
StatusPublished - 2018
PublikationskategoriForskning
Peer review utfördJa

Nedladdningar

Ingen tillgänglig data

Related projects

Jan-Eric Ståhl, Volodymyr Bushlya, Daniel Johansson, Christina Windmark, Filip Lenrick, Aylin Ahadi, Mathias Agmell, Mikael Hörndahl & Oleksandr Gutnichenko

European Commission - Horizon 2020

2017/09/012019/12/31

Projekt: ForskningInternationellt samarbete

Visa alla (1)