Effect of injection timing on the ignition and mode of combustion in a HD ppc engine running low load

Forskningsoutput: Kapitel i bok/rapport/Conference proceedingKonferenspaper i proceeding

Abstract

This work aims to study the effect of fuel inhomogeneity on the ignition process and subsequent combustion in a compression ignition Partially Premixed Combustion (PPC) engine using a primary reference fuel (PRF) in low load conditions. Five cases with injection timings ranging from the start of injection (SOI) at -70 crank angle degrees (CAD) to -17 CAD have been studied numerically and experimentally in a heavy duty (HD) piston bowl geometry. Intake temperature is adjusted to keep the combustion phasing constant. Three dimensional numerical simulations are performed in a closed cycle sector domain using the Reynolds Averaged Navier-Stokes (RANS) formulation with k-ϵ turbulence closure and direct coupling of finite rate chemistry. The results are compared with engine experiments. The predicted trends in required intake temperature and auto-ignition location for a constant combustion phasing are consistent with experiments. The simulations show that the auto-ignition is critically dependent on both fuel and temperature stratification. The ignition occurs in fuel-lean regions but the mixing of the fuel with the cylinder gas and the cylinder gas temperature stratification (prior to injection) determines the ignition location. A higher heat release rate is observed in the later injection cases, which is attributed to the higher equivalence ratio of the mixture inside the bowl. Negative temperature coefficient (NTC) heat release behaviour of the studied fuel plays a role in shortening the ignition wave propagation but the impact of the effect varies among the injection cases. A sensitivity study of combustion efficiency with regard to the intake temperature is performed on two of the cases (SOI of -30 CAD and of -63 CAD). While the combustion phasing is slower and correctly predicted in the simulations of the advanced injection cases the combustion efficiency is found to be very sensitive to the intake temperature. This is attributed to the high sensitivity of the ignition delay time to equivalence ratio and temperature.

Detaljer

Författare
Enheter & grupper
Forskningsområden

Ämnesklassifikation (UKÄ) – OBLIGATORISK

  • Energiteknik
Originalspråkengelska
Titel på värdpublikationTechnical Paper - WCX SAE World Congress Experience
Volym2019
StatusPublished - 2019 apr 2
PublikationskategoriForskning
Peer review utfördJa
EvenemangSAE World Congress Experience, WCX 2019 - Detroit, USA
Varaktighet: 2019 apr 92019 apr 11

Publikationsserier

NamnSAE Technical Papers
FörlagSociety of Automotive Engineers
ISSN (tryckt)0148-7191

Konferens

KonferensSAE World Congress Experience, WCX 2019
Förkortad titelWCX 19
LandUSA
OrtDetroit
Period2019/04/092019/04/11

Relaterad forskningsoutput

Christian Ibron, 2019 nov 18, Lund: Department of Energy Sciences, Lund University. 82 s.

Forskningsoutput: AvhandlingDoktorsavhandling (sammanläggning)

Visa alla (1)