Immobilisation of lipases by adsorption and deposition: High protein loading gives lower water activity optimum

Forskningsoutput: TidskriftsbidragArtikel i vetenskaplig tidskrift

Abstract

Two different immobilisation techniques for lipases were investigated: adsorption on to Accurel EP-100 and deposition on to Celite. The specific activities were in the same order of magnitude, 2.9 (μmol min -1 mg protein) when Celite was used as support and 2.3 (μmol min -1 mg -1 protein) when Accurel EP-100 was used as support, even if the amount of lipase loaded differed by 2 orders of magnitude. Immobilisation on Accurel EP-100 was the preferred technique since 40-100 times more protein can be loaded/per g carrier, thus yielding a more active catalyst. The water activity profiles in lipase catalysed esterification were influenced by the amount of protein adsorbed to Accurel EP-100. Higher protein loading (40 mg g -1) resulted in a bell-shaped water activity profile with highest specific activity (6.1 μmol min -1 mg -1 protein) at a(w) = 0.11, while an enzyme preparation with low protein loading (4 mg g -1) showed highest specific activity at a(w) = 0.75.

Detaljer

Författare
Enheter & grupper
Externa organisationer
  • Lund University
Forskningsområden

Ämnesklassifikation (UKÄ) – OBLIGATORISK

  • Biokatalys och enzymteknik

Nyckelord

Originalspråkengelska
Sidor (från-till)1571-1575
Antal sidor5
TidskriftBiotechnology Letters
Volym22
Utgivningsnummer19
StatusPublished - 2000 nov 27
PublikationskategoriForskning
Peer review utfördJa