Fabrication of sample target plate for MALDI-TOF MS using proton beam writing

Anton Ressine, Vaida Auzelyte, Per Kristiansson, György Marko-Varga, Thomas Laurell

Forskningsoutput: TidskriftsbidragArtikel i vetenskaplig tidskriftPeer review

Sammanfattning

Ion beam irradiation of silicon followed by electrochemical etching has been used to produce fluid anchor points on a sample target plate for matrix assisted laser desorption ionization mass spectrometry. Non-porous areas on the fabricated target plate serve as anchor points for sample deposition. High hydrophobicity of the macroporous silicon surface surrounding anchor points intrinsically led to a better sample confinement and gave the possibility to deposit large volumes of sample at predefined spot areas, improving the sensitivity in bioanalyte readout. We also have found that irradiation with beam fluences lower than 1014 cm−2 led to the enhanced anodization rate producing inverse structures.
Originalspråkengelska
Sidor (från-till)715-718
TidskriftNuclear Instruments & Methods in Physics Research. Section B: Beam Interactions with Materials and Atoms
Volym249
Nummer1-2
DOI
StatusPublished - 2006

Bibliografisk information

The information about affiliations in this record was updated in December 2015.
The record was previously connected to the following departments: Nuclear Physics (Faculty of Technology) (011013007), Analytical Chemistry (S/LTH) (011001004), Biomedical Engineering (011200011)

Ämnesklassifikation (UKÄ)

  • Medicinteknik

Fingeravtryck

Utforska forskningsämnen för ”Fabrication of sample target plate for MALDI-TOF MS using proton beam writing”. Tillsammans bildar de ett unikt fingeravtryck.

Citera det här