Flame investigation of a gas turbine central pilot body burner at atmospheric pressure conditions using oh plif and high-speed flame chemiluminescence imaging

Experiments were performed on the central pilot body (RPLrich- pilot-lean) of Siemens prototype 4th generation DLE burner to investigate the flame behavior at atmospheric pressure condition when varying equivalence ratio, residence time and co-flow temperature. The flame at the RPL burner exit was investigated applying OH planar laser-induced fluorescence (PLIF) and high-speed chemiluminescence imaging. The results from chemiluminescence imaging and OH PLIF show that the size and shape of the flame are clearly affected by the variation in operating conditions. For both preheated and non-preheated co-flow cases, at lean equivalence ratios combustion starts early inside the burner and primary combustion comes to near completion inside the burner if residence time permits. For rich conditions, the unburnt fuel escapes out through the burner exit along with primary combustion products and combustion subsequently restarts downstream the burner at leaner condition and in a diffuse-like manner. For preheated co-flow, most of the operating conditions yield similar OH PLIF distributions and the flame is stabilizing at approximately the same spatial positions. It reveals the importance of the preheating co-flow for flame stabilization. Flame instabilities were observed and Proper Orthogonal Decomposition (POD) is applied to time resolved chemiluminescence data to demonstrate how the flame is oscillating. Preheating has strong influence on the oscillation frequency. Additionally, combustion emissions were analyzed to observe the effect on NOX level for variation in operating conditions.